MME Admission Requirements

  For students applying for 300-level MME course admission FALL 2022

Terms of Admission & Deadlines

• Fall admission only

• Application deadline is April 15

• MME application is on department website: www.pdx.edu/mechanical-materials-engineering/bsme-admission

• If not a current PSU student, please apply first to PSU: www.pdx.edu/admissions/undergraduate-admissions

Minimum Eligibility for Consideration

• All required/shaded classes on the BSME course plan completed prior to fall 2022 with a grade of C or better. A C- will not count as meeting admission criteria.

• A Selective Admission GPA of 2.25 or higher. The Selective Admission GPA is calculated using only the required/shaded courses on the BMSE course plan, excluding Freshman Inquiry or, for transfers, Wr 121 and Comm 220.

• Freshman Inquiry (for those who began PSU as freshman) or Wr 121 and Comm 220 (for transfer students) must be completed prior to fall

Selective Admission

• All students who meet the minimum grade requirement and have no more than 6 required/shaded

• Selective Admission GPA courses outstanding as of April 15, 2022 will be considered. The outstanding

• courses must be completed prior to the start of fall term. Examples:

  • OK =

    • Spring 2022 – EAS 212, EAS 215, ME 122, Mth 261

    • Summer 2022 – Mth 256, Ph 213/216, Comm 220

    • 7 classes total, 6 are required for GPA

  • Not OK =

    • Spring 2022 – EAS 212, EAS 215, ME 122, Mth 261

    • Summer 2022 – Mth 256, Ph 213/216, ECE 241

    • 7 classes total, 7 are required for GPA

• Selective Admission GPA will not be calculated for any student until winter grades are received by the MME Department. Students with a Selective GPA of 2.50 or above will be conditionally admitted into the program. Conditions will be the completion of outstanding required courses, outlined in the admission letter. A ‘pending spring grades’ decision will be relayed to students with a Selective GPA below 2.50. Transfer students who do not provide unofficial transcripts with winter grades may be denied admission. Transcripts can be sent to mmedept@pdx.edu.

• Admission will be offered to the top students (approximately 120), including conditionally admitted students, based on their Selective Admission GPA.

  • If a conditionally admitted student does due diligence and cannot locate the necessary

 course(s) at PSU or local community colleges, it is possible the condition may be extended through end of fall. Extension must be approved by the MME Academic Advisor. Official transcripts must be provided to both PSU Admissions Office and MME Department once grades post to determine if the conditions were met.

• Admission decisions will generally be communicated to students via email by May 15, 2022. Decisions will be:

  • Admit

  • Conditionally Admit

  • Pending spring Grades (official decision will be sent after spring grades are evaluated)

  • Deny (students may request a meeting with the MME Academic Advisor to review decision)

Repeated Classes

• Standard PSU repeat/replace policy applies to Selective Admission GPA:

  • If a student earned a D+ or below in a class the first time, then only the repeated (second) grade will be used in the Selective GPA calculation

  • If a student earned a C- or above in a class the first time, then both the first grade and the second (repeated) grade will be used in the Selective GPA calculation

  • Should a class be taken a third time it does not replace the second attempt regardless of either grade

Additional Testing

• No test required

Pass/No Pass

• Required classes must be taken for a grade (not P/NP)

  • Note: Due to COVID-19, P grades will be accepted for courses completed during spring 2020 through spring 2021 only. Please reach out to mmedept@pdx.edu for additional information.

• If a student earns a NP in a required class it will be calculated in selective admission GPA as an F and the course must be taken for a grade

  • Note: There is no COVID-19 exception to the NP policy

Additional Information (exceptions, preferences, etc.)

• No preference given to PSU students versus students who completed required/shaded courses elsewhere

Department Communication

• The MME Department (mmedept@pdx.edu) will communicate to students via email. If the student has a pdx.edu email, all email communications will be sent to that address.

• Fall 2023 admission requirements available spring 2022 (in time for fall 2022 registration in May 2022)

Eligibility

Students must complete the following required/shaded courses with a minimum grade of C:

Ch 221	General Chemistry I	4
Ch 222	General Chemistry II	4
Ch 227	General Chemistry Laboratory	1
Ch 228	General Chemistry Laboratory	1
EAS 211	Statics	4
EAS 212	Strength of Materials	4
EAS 215	Dynamics	4
ECE 241	Introduction to Electrical Engineering	4
ECE 241L	Introduction to Electrical Engineering Lab	0
ME 120	An Introduction to Engineering	3
ME 121	Introduction to Systems and Control	3
ME 122	Introduction to Design	3
Mth 251	Calculus I	4
Mth 252	Calculus II	4
Mth 254	Calculus IV	4
Mth 256	Applied Ordinary Differential Equations	4
Mth 261	Introduction to Linear Algebra	4
Ph 211	General Physics (with Calculus) I	4
Ph 212	General Physics (with Calculus) II	4
Ph 213	General Physics (with Calculus) III	4
Ph 214	Lab for Ph 201 or Ph 211 or Ph 221 or Ph 231	1
Ph 215	Lab for Ph 202 or Ph 212 or Ph 222 or Ph 232	1
Ph 216	Lab for Ph 203 or Ph 213 or Ph 223 or Ph 233	1
	Freshman Inquiry	15

Continuation Criteria

After admission to the BSME Program students will be expected to make satisfactory progress toward their declared degree and will be subject to the following rules:

1. The term GPA in all courses taken at PSU must be 2.00 or higher. 

2. At the conclusion of each term of the academic year, full-time students are normally expected to complete a minimum of 12 credits applicable toward their degree program. Part-time students are expected to complete a minimum of 12 credits per year applicable toward their degree program.

3. Students will be placed on probation when their term GPA as described in (1) is below 2.00, or their progress toward the degree is less than that described in (2).

4. Students placed on probation for two consecutive terms or for a total of three terms will be suspended from the BSME program. Students also will be suspended if not enrolled in engineering and/or computer science courses for three consecutive terms.

5. Students who are suspended must meet with an advisor to determine whether and under which conditions readmission is feasible.

6. Students must have a major GPA of at least 2.0 in order to graduate with their BSME.

Appeals

Students denied admission or suspended may request reconsideration by submitting a petition. The petition and supporting materials will be reviewed by the Undergraduate Advisor of the Mechanical & Materials Engineering Department; a recommendation will be forwarded to the Chair.  The Advisor's decision can be appealed by the Chair.  Appeals must be made within 30 days of denial of admission or suspension notification.

Pass/No Pass Grading Policy

All courses specifically required by the University or by the Department must be taken for a letter grade unless a required course is only offered with a pass/no pass option.